PU Gule Polioli polieter bicomponent pentru filtre de aer

PU Gule Two Component Polyether Polyols For Air Filters

Scurtă descriere:

Part A polyurethane system for air filter is composed of hyperactive polyether polyols, cross linking agent, compound catalyst and so on. Part B is modified isocyanate, and it is micro-pore elastomer which adopts cold moding. It has excellent mechanical and anti-fatigue property. Also, with short production cycle, high efficiency and low energy consumption. So, it is widely applied to manufacture air filter cores of cores of cars, ships, construction machinery, generator and other internal combustion machinery’s.

Send Email to Us Descărcați ca PDF

Detaliu produs

Etichete de produs

Instructions:

1. Material-A should stirred evenly with plastic hand electric drill, material-B can shake, before used.

2. Open the electrocaloric plate temperature to 40-50 degrees, in winter material-A and material-B with a small container to preheat.

3. Wipe the mould with release agent

4. According to the local environment, such as the humidity in the air, workshop environment.

5. material-A and material-B are mixed at the mixture ratio of 100:40 ratio, then add 40% talcum powder(heavy calcium powder)(100:40:50±5), with 2800 rev / min motor to mix, mixing time determined by the amount of adhesive, per 100g of adhesive is approximately 7-10 seconds .

6. Pour the Mixed liquid into mould, then put the paper element and give a little pressure on it. 8-15 minutes later you can bring the mould down

Anterior: Linie de producție de plisare a hârtiei de filtru HEPA de 300 mm

Următorul: Filtru de praf cu cartuș de îndepărtare industrială

Dacă sunteți interesat de produsele noastre, puteți alege să lăsați informațiile dvs. aici și vă vom contacta în scurt timp.